Magazine Archive

Home -> Magazines -> Issues -> Articles in this issue -> View

Maine Standard amp/115 cab

Article from Sound International, September 1978

An amp at last - Colin Hodgkinson plugs in to a Maine Standard/115 set-up.



It was purely a matter of necessity the first time I tried a Maine amplifier. The night before a valve and a capacitor had blown on my Fender 400PS; there I was, faced with an important gig and no amplifier. My friendly local music dealer, however, was most sympathetic and suggested that I take the Maine and try it — I didn't really have a choice as it was the only bass amp that they had available.

I was naturally very dubious. I'm a confirmed valve sound man and my reasons for being so are probably the same as those of most other musicians who prefer valve amps; solid state amps are cold — they have no sustain — and they have no warmth, no guts, no character etc, etc. However on this occasion I had no choice, and being cruel but fair I decided to give it a try and keep my large but sensitive ears open in an unbiased fashion.

I have to admit that I was very pleasantly surprised. I was doing a clinic that night and I made all the demands on the Maine that I normally would on my Fender: a lot of jamming, rhythmic patterns with the drummer, and also several solo things I usually play involving the use of a lot of chords and melody lines on the bass. The Maine had great sounds; the tone controls were really very sensitive, giving all the chords I played lovely separation, each note coming over in a clear and balanced way. There was power to spare, which for a change meant that the manufacturer's power ratings were accurate — most important to me, though, the sound had warmth.

My initial reaction was that it had to be my cabinet, a 2 x 15 JBL which I've used continually for over five years, that was helping things. So, to check this out properly, I tried the Maine the next day with the Maine 115 Bass Bin and it really sounded just as good. Well, almost! I don't think that a Celestion is any match for a JBL, but that's purely a personal opinion and besides, Maine can supply their cabinet empty so that you can fit the speaker of your choice.

A little physical info for DIY musicians, roadies etc: the amp weighs 36lbs and measures 24in long x 12in wide x 6in high. Rear panel connections include an anchored cable mains power lead, three loudspeaker output jacks, a slow-blow 2-5amp fuse, plus jacks for 'loop input', 'loop output' and booster output. The front panel controls, which you can see in the photo, are Level and Overload distortion, Presence, Bass, Middle and Treble, Record jack, Volume (master), high and low gain input jacks, and a mains indicator lamp.

The 115 Bass Bin measures 24in wide x 23in deep x 36½in high and comes, as do all Maine cabs, with a PVC cover and connecting jack lead. It's a direct exponential radiator enclosure with reflex port, rear loaded driver and removable baffle grille. There are two loudspeaker options, apart from that of buying it empty: either a Celestion handling 125watts RMS, or an Altec handling 150watts RMS.

After asking around a little I found out that Maine was developed by a couple of musicians who were dissatisfied with currently available gear and so decided to build their own. This always seems a plus to me because musicians invariably know what fellow musicians want from amps and other equipment.

As I've already mentioned, the tone controls on the Standard are really sensitive, and the overload distortion feature is very effective. This is a nice device because you can achieve just the right amount of distortion, from the 'valve sound' type, right up to the downright filthy.

There's bags of power too, and the idea of three outputs is great because it allows you to use different types of speaker setups for different venues — and what really impressed me was the fact that the tone didn't change too much when the volume was increased, something that can be said of only a few amps around at the moment. I like the design too, very functional and extremely portable for an amp of this power output.

Finally I must say that I haven't changed my mind about valve amps! A couple of other firms (who shall remain nameless) sell large quantities of solid state amps that leave me cold; they just don't come anywhere near the Maine for warmth or character, at least for me. I find it encouraging, though, that someone has come close to what is everyone's ideal: the superior performance of a solid state circuit with the heart and soul of the classic valve amplifiers.

rrp: Standard Amp £179.80/not available in US
rrp: 115c Bass Cab £244.91/not available in US


Colin Hodgkinson was bassist with Back Door until their split in 1977, and is currently involved in session work and the MU rock workshops.

Manufacturer's Specification

Standard Amplifier
Output power: 200watts RMS at 5% THD into 4ohms; 180watts RMS at 1% THD into 4ohms; 105watts RMS at 1% THD into 8ohms; 70watts RMS at 1%THD into 16ohms.
Music power output: 300watts.
Minimum load: 2ohms.
Output power at 2ohm load: 260watts RMS at 1%THD.
Mains power: Ratings taken at: 1 KHz 240volts AC line, European models; 1 KHz 120volts AC line, American models.
Record output impedance: 1V RMS at 4K7 unbalanced.
Input impedance: High gain 250K ohms; Low gain 47K ohms.



Previous Article in this issue

Ibanez Artist Series

Next article in this issue

Pearl Maple


Publisher: Sound International - Link House Publications

The current copyright owner/s of this content may differ from the originally published copyright notice.
More details on copyright ownership...

 

Sound International - Sep 1978

Donated & scanned by: Mike Gorman

Previous article in this issue:

> Ibanez Artist Series

Next article in this issue:

> Pearl Maple


Help Support The Things You Love

mu:zines is the result of thousands of hours of effort, and will require many thousands more going forward to reach our goals of getting all this content online.

If you value this resource, you can support this project - it really helps!

Donations for November 2026
Issues donated this month: 0

New issues that have been donated or scanned for us this month.

Funds donated this month: £0.00

All donations and support are gratefully appreciated - thank you.


Magazines Needed - Can You Help?

Do you have any of these magazine issues?

> See all issues we need

If so, and you can donate, lend or scan them to help complete our archive, please get in touch via the Contribute page - thanks!

Please Contribute to mu:zines by supplying magazines, scanning or donating funds. Thanks!

Monetary donations go towards site running costs, and the occasional coffee for me if there's anything left over!
muzines_logo_02

Small Print

Terms of usePrivacy